chemical wear abrasion resistant ceramic tile bonding repair adhesive

The description of BD120 anti wear abrasion chemical resistant epoxy ceramic tile bonding adhesives

http://www.wearcoating.com/case-of-desulfuration-pipeline-repairing-coatings/chemical_wear_abrasion_resistant_ceramic_bonding_adhesive_4366.html

performance features of our BD120 ceramic epoxy bonding chemical abrasion wear resistant adhesive:
1.Two component,white semi-fluid,popular type,the highest temperature resistant is 150 degree.
2.It’s consist of modified heat resistant toughening resin and special curing agent.
3.Aging resistant(can reach more than 8 years),good toughness.
4.Can cure at room temperature,can also heat for curing.
5.Used in the bonding of wear resistant ceramic tile under the temperature of 120 degree.

product usage of our BD120 epoxy ceramic tile bonding wear abrasion chemical resistant adhesives:
with high bonding strength and good toughness,with very high adhesive strength based on steel,cement,ceramic,aluminum alloy,stainless steel
and other various materials,especially suitable for the bonding of wear resistant ceramic chip.Suitable for the bonding of wear resistant ceramic
tile on the equipment of suffering from ash powder scour and materials strong scour or erosive wear.

How to use of our chemical wear abrasion resistant epoxy bonding ceramic tile adhesive:
1.Surface treatment: Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend,
clean it by cleaning agent in the end.

2.Configure adhesive: According to the specified requirements,make A and B two components mix uniformly   A:B=4:1

3.Using adhesive: Make configured adhesive spread coating on the surface of adherend uniformly,then fold it,knock it from
the middle to all around with the rubber hammer for once, avoid getting into the air in the middle.

4.Curing:Initial curing for 4 hours at the room temperature,fully curing for 24 hours(15~  18MPa),if you heat it up to the temperature of 80 degree and keep this temperature for 2 hours,then do the last curing,
in this way,can get the higher combination property(can improve 30%)

120%e5%89%af%e6%9c%ac

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s