high temperature wear resistant epoxy bonding ceramic adhesive

The description of BD180 bonding epoxy ceramic anti abrasion wear high temperature resistant adhesives

http://www.wearcoating.com/case-of-desulfuration-pipeline-repairing-coatings/high_temperature_wear_resistant_epoxy_ceramic_adhesives_4375.html

Performance features of our BD180 high temperature wear abrasion resistant ceramic tile epoxy adhesive:
1.Two component,gray semi-fluid,the highest temperature resistant is 200 degree.
2.It’s consist of modified heat resistant toughening resin and special curing agent.
3.Aging resistant(can reach more than 8 years),high temperature resistant,good toughness
4.Can cure at room temperature,can also heat for curing.

Product usage of our BD180 epoxy paste ceramic tile high temperature wear abrasion resistant adhesives:
With high bonding strength and good toughness,with very high bonding force to steel,cement,ceramic,
aluminum alloy,stainless steel etc.various materials.Especially suitable for the bonding of wear resistant ceramic tile,
suitable for sticking the wear resistant ceramic tile based on medium speed coal mill cones,coarse powder separator,
exhauster,coal dust pipeline etc.suffered ash powder scour equipment and the equipment of suffering from material
strong scour or erosive wear in the industries of steel,cement,chemical etc.

How to use of our BD180 anti wear abrasion resistant ceramic bonding high temperature adhesive:
1.Surface treatment: Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend,
clean it by cleaning agent in the end.

2.Configure adhesive: According to the specified requirements,make A and B two components mix uniformly A:B=4:1

3.Using adhesive: Make configured adhesive spread coating on the surface of adherend uniformly.Double spread,
the bonding effect will be better.

4.Curing: Initial curing at the room temperature for 1~1.5 hours,fully curing for 24 hours,heat it up to the temperature of 80
degree and keep this temperature for 2 hours,then do the last curing,in this way,it can get the higher strength(≥18MPa)

5.Every time the suitable quantity of configuring adhesive is 300g~500g,too much adhesive is not easy to mix uniformly,every time the usable time of configuring adhesive is about 30~40 min,the usable time is long at the low temperature,the usable time is short at the high temperature,should adjust the
configured adhesive quantity according to the actual condition.

180%e5%89%af%e6%9c%ac

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s