they will brush a layer of anti abrasion corrosion resistant rubber on the inner wall of the equipment.The lining rubber has two methods,
one is cold sticking method,make the cutting out of molding rubber plate paste on the equipment inner wall with the adhesive,
this method is simple,but because the corrosion resistance and water resistance of the adhesives are not ideal,
the rubber lining will often appear the debonding,bump even large area falling off etc.
phenomenon along the cutting slit in the process of using,lose the intrinsical protection effect,lead to the engineering failure,
the other is hot vulcanization method,vulcanizate a layer of rubber on the inner wall of flotation cell directly.
not suitable for field maintenance.Based on this phenomenon,our company developed a new type of pyrite flotation cell special
anti wear corrosion resistant coating(BD7052 flotation cell special abrasion & corrosion resistant coatings) is the high performance
anti abrasion corrosion resistant polymer material compounded by the high performance wear resistant particles
(silicon carbide and carborundum etc.) and modified resin.This material is a combination of excellent corrosion resistance from
high polymer material and excellent abrasion resistance from silicon carbide,alumina particles.Has good wear resistance,
excellent corrosion resistance,strong adhesive strength and good cavitation resistance.Especially suitable for repairing the potion
corrosion from flotation cell inner wall and wear corrosion caused by mineral grains,or the preparation of wear resistant corrosion
resistant pre-protective coating on the inner wall of flotation cell directly.